DS7200V2-EXP - Simon Technologies

DS7200V2-EXP | Installation Guide | 3. Control Panel Programming EN | 82Location ##, Zone Function• Address: See Table 30 on page 79• Default: See Table 30 on page 79• Selections: 0 to 15 (see Table 31 for Default Zone Function Types)The zone function determines how the system responds to changes on the sensor loop assigned to the location.There are two general categories of zones: 24-hour and Controlled.• 24-hour Zone: 24-hour zones are always on and cannot be turned off by the user. Faults on 24-hour zonesprevent turning the system on.• Controlled Zone: Controlled zones are turned on and off when the user turns the system on (armed) and off(disarmed).See Table 31 for default zone function selections.Table 31: Default Zone Function Type SelectionsZone FunctionSelection0 DisabledDefault Zone Function Type1 24-hour Fire, Normally Open Contact2 24-hour Fire with Alarm Verification, Normally Open Contact3 24-hour Voice Active Control Input, Normally Open Contact with EOL Resistor4 24-hour Tamper (no EOL resistor)5 24-hour Emergency (no alarm output)6 24-hour Visible Panic (no alarm output)7 24-hour Invisible Panic (no alarm output)8 24-hour Burglary9 Chime Mode only10 Controlled Keyswitch, Momentary, All On, Off from Any Armed State11 Controlled Entry/Exit Delay 112 Controlled Entry/Exit Delay 213 Controlled Follower14 Controlled Instant15 Controlled Instant (Perimeter)24-Hour ZonesControlledZonesLocation ##, Area• Address: See Table 30 on page 79• Default: Area 1• Selections:- 0 = No Area Assigned (Disabled)- 1 = Assign Location ## to Area 1- 2 = Assign Location ## to Area 2- 3 = Assign Location ## to Area 3 (DS7240V2 only)- 4 = Assign Location ## to Area 4 (DS7240V2 only)This parameter assigns an area to a location. Each location can only be assigned to one area.Bosch Security Systems, Inc. | 2/09 | 4998153893-03