Adept Cobra s600/s800 Robot User's Guide - pulsar.com.tr

Chapter 2 - Safety
2.6 Transport
Always use adequate equipment to transport and lift <strong>Adept</strong> products. See Chapter 3 for
more information on transporting, lifting, and installing.
WARNING: Do not remain under the robot while it is
transported.
2.7 Safety Requirements for Additional Equipment
Additional equipment used with the <strong>Adept</strong> <strong>Cobra</strong> s-series robot (grippers, conveyor belts,
etc.) must not reduce the workcell safeguards.
All emergency stop switches must always be accessible.
If the robot is to be used in an EU or EEA member country, all <strong>com</strong>ponents in the robot
workcell must <strong>com</strong>ply with the safety requirements in the European Machine Directive
89/392/EEC (and subsequent amendments) and related harmonized European,
international, and national standards. For robot systems, these include: EN 775/ISO
10218, sections 5,6; EN 292-2; and EN 60204. For safety fences, see EN 294.
In other countries, <strong>Adept</strong> strongly re<strong>com</strong>mends, in addition to <strong>com</strong>plying with the
applicable local and national regulations, that a similar level of safety be obtained.
In the USA, applicable standards include ANSI/RIA R15.06 and ANSI/UL 1740.
In Canada, applicable standards include CAN/CSA Z434.
2.8 Sound Emissions
The sound emission level of the <strong>Adept</strong> <strong>Cobra</strong> s-series robot depends on the speed and
payload. The maximum value is 90dB. (This is at maximum AUTO-mode speed.)
WARNING: Acoustic emission from this robot may be up
to 90dB (A) under worst-case conditions. Typical values
will be lower, depending on payload, speed, acceleration,
and mounting. Appropriate safety measures should be
taken, such as ear protection and display of a warning
sign.
28 <strong>Adept</strong> <strong>Cobra</strong> <strong>s600</strong>/<strong>s800</strong> <strong>Robot</strong> User’s <strong>Guide</strong>, Rev C