Altivar 61 - error

[1.5 INPUTS / OUTPUTS CFG] (I-O-)
Code
Description
tCC Terminal display: [2/3 wire control]
Logic address: 11101 = 16#2B5D Type: WORD (listing)
CANopen index: 2051/2 Read/write: R/WS
INTERBUS index: 5FBC/EC Factory setting: 0
DeviceNet path: 98/01/66
0=[2 wire] (2C): 2-wire control
1=[3 wire] (3C): 3-wire control
tCt Terminal display: [2 wire type]
Logic address: 11102 = 16#2B5E Type: WORD (listing)
CANopen index: 2051/3 Read/write: R/WS
INTERBUS index: 5FBC/ED Factory setting: 1
DeviceNet path: 98/01/67
0=[Level] (LEL): State 0 or 1 is taken into account for run or stop.
1=[Transition] (trn): A change of state (transition or edge) is necessary to initiate operation, in order to prevent
accidental restarts after a break in the power supply.
2=[Fwd priority] (PFO): State 0 or 1 is taken into account for run or stop, but the "forward" input always takes priority
over the "reverse" input.
rrS Terminal display: [Reverse assign.]
Logic address: 11105 = 16#2B61 Type: WORD (listing)
CANopen index: 2051/6 Read/write: R/WS
INTERBUS index: 5FBC/F0 Factory setting: According to tCC (1)
DeviceNet path:
98/01/6A
Assignment of the reverse direction command:
0=[No] (nO): Not assigned
129 = [LI1] (LI1)
:
142 = [LI14] (LI14)
In I/O profile only:
160 = [CD00] (Cd00)
:
175 = [CD15] (Cd15)
177 = [C101] (C101)
:
239 = [C415] (C415)
See: “Assignment conditions for logic inputs and control bits”, page 181.
ACC and dEC are enabled when the assigned input or bit is at 0.
AC2 and dE2 are enabled when the assigned input or bit is at 1.
(1) According to tCC, see “tCC”, page 157.
If tCC = 0: Factory setting = [LI2] (LI2)
If tCC = 1: Factory setting = [LI3] (LI3)
157