Altivar 61 - error

[1.7 APPLICATION FUNCT.] (FUn-)
[OUTPUT CONTACTOR CMD] (OCC-)
Code
Description
OCC Terminal display: [Out. contactor ass.]
Logic address: 13104 = 16#3330 Type: WORD (listing)
CANopen index: 2065/5 Read/write: R/WS
INTERBUS index: 5FBD/3D Factory setting: 0
DeviceNet path:
A2/01/69
Logic output or control relay
0=[No] (nO): Function not assigned (in this case, none of the function parameters can be accessed)
129 = [LO1] (LO1): Logic output (if one or two I/O cards have been inserted, LO1 to LO2 or LO4 can be selected)
130 = [LO2] (LO2)
131 = [LO3] (LO3)
132 = [LO4] (LO4)
146 = [R2] (r2): Relay (selection of R2 extended to R3 or R4 if one or two I/O cards have been inserted)
147 = [R3] (r3)
148 = [R4] (r4)
rCA Terminal display: [Output contact. fdbk]
Logic address: 13103 = 16#332F Type: WORD (listing)
CANopen index: 2065/4 Read/write: R/WS
INTERBUS index: 5FBD/3C Factory setting: 0
DeviceNet path:
A2/01/68
0=[No] (nO): Not assigned
129 = [LI1] (LI1)
:
142 = [LI14] (LI14)
160 = [CD00] (Cd00)
:
175 = [CD15] (Cd15)
177 = [C101] (C101)
:
239 = [C415] (C415)
See: “Assignment conditions for logic inputs and control bits”, page 181.
The motor starts up when the assigned input or bit changes to 0.
dbS Terminal display: [Time to motor run]
Logic address: 13101 = 16#332D Type: UINT
CANopen index: 2065/2 Read/write: R/W
INTERBUS index: 5FBF/A6 Unit: 0.01 s
DeviceNet path: A2/01/66 Factory setting: 15
Time delay for:
• Motor control following the sending of a run command
• Output contactor fault monitoring, if the feedback is assigned
Adjustment range: 5 to 6000
219