model 2704 controller installation and operation handbook - Soliton

Programmer Operation
2704 Controller
13. Press to select
‘PSP1 Rate’
14. Press or to
adjust the value
The setpoint will ramp to
600 at the rate of 25 units
per sec, min or hour, as set
in PROGRAM EDIT
(Program Page).
If PSP1 Type = Dwell
This parameter is Dwell Tm
If PSP1 Type = Step
This parameter is omitted
15. Continue to press to select further parameters for Segment 1, and to change their
values using or .
16. Now set up Segment 2 by repeating the above steps.
Tip - A back and forward scroll is available by holding down and pressing or
respectively
17. Repeat the procedure until all segments have been set up. The last segment should be
defined as ‘Segment Type = End Segment’.
6-26 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00