model 2704 controller installation and operation handbook - Soliton

2704 Controller Analogue Operators
9. Press to select
Input 2 Scalar
This scalar is used as a
multiplying factor on input 2
10. Press or to
change the value
11. Press to select
Input 1 Value
This is a read only value of
input 1
12. Press to select
Input 2 Value
This is a read only value of
input 2
13. Press to select
Output Value
This is a read only value of
the result of the
calculation.
[Units] If units have been
selected in configuration level
they will be displayed here.
14. Press to select
Status
The result of the
calculation is Good or Bad.
Eg. It is within high and
low limits set in
configuration level.
Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00 14-5