model 2704 controller installation and operation handbook - Soliton

2704 Controller Module IO
18.3.3. Triac Output
Table Number:
18.3.3.
This page allows you to set the parameters for
a Triac Output module.
Triac
Dual Triac
Ident Triac
Ident Dual Triac
MODULE IO
(Module x(A)
Page)
Parameter Name Parameter Description Value Default Access
Level
Ident Triac R/O
The following five parameters only appear if the output is configured as ‘Time Proportion’.
Min Pulse Time Minimum relay on or off time Auto = 0.05s
or
0.1 to 999.9
20sec L3
Only
Electrical Lo Electrical low input level O/P range shown
Electrical Hi Electrical high input level O/P range for time
Eng Value Lo Low display reading Disp. range prop.
Eng Value Hi High display reading Disp. range O/Ps
Electrical Val
Module x A Val
The current electrical value
of the output
The current output value
Module x A can be a user
defined name
0.00 or 1.00 R/O
+ 100%
-ve values
are shown
but not used
The triac output is a single output module. The parameters above are displayed under
‘channel’ (A) only.
R/O
The dual triac has two outputs. The parameters above are displayed under Channel (A) and
Channel (C ).
Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00 18-7