model 2704 controller installation and operation handbook - Soliton

2704 Controller Programmer Operation
6.7. TO CREATE OR EDIT A PROGRAM
To create or edit a program it is first necessary to define the parameters associated with the
overall program. These parameters will be found under the page header ‘PROGRAM EDIT
(Program)’, see section 6.7.1. and 6.7.2.
Then set up the parameters which define each individual segment. These parameters will be
found in the page ‘PROGRAM EDIT (Segments)’, see section 6.7.3. and 6.7.4.
Notes:-
1. A running program cannot be edited, it must be put into Reset or Hold mode.
2. Changes can be made to any segment of a currently running program as follows:-
• To the currently running segment - use the PROGRAM RUN page. These changes are
always temporary and apply to the current run only
• To segments subsequent to the current segment - use the PROGRAM EDIT page. These
changes are always permanent and will apply to subsequent runs Changes can be made to
the current segment in the PROGRAM EDIT page but do not take effect in the currently
running program.
3. Other programs can be created or edited when another program is running.
6.7.1. To Access the Program Edit pages
Do This
1. From any display press
to access the page header
menu.
This Is The Display You
Should See
Additional Notes
2. Press or to select
‘PROGRAM EDIT’
3. Press to show subheaders
4. Press or (if
necessary) to select
‘Program’
This page allows the
overall programmer
parameters to be defined
5. Press to show
parameters
6. Press again to select
the highlighted parameter
The value of a parameter
prefixed by ! can be
changed using or
The full list of parameters is
shown in the following table
Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00 6-17
…