model 2704 controller installation and operation handbook - Soliton

User Values
2704 Controller
13.2. WHAT ARE USER VALUES?
User Values are normally used as constants in an analogue or digital operation.
The 2704 controller contains up to 12 user values which are in a single list under the page
header ‘User Values’. The User Values page is only available if Analogue and Logic
Operators have been enabled in configuration level. This is described in the Engineering
Handbook Part No. HA026933.
13.2.1. To Adjust User Values
Do This
1. From any display press
as many times as necessary
to access the page header
menu
This Is The Display You
Should See
Additional Notes
2. Press or to select
‘USER VALUES’
3. Press to show Subheaders
4. Press or to
select ‘User Val 1 (to
12)’
3. Press to show the
parameter list
4. Press or to
change the value
The value can be adjusted
between high and low
limits as set in
configuration level.
[Units] If units have been selected in configuration level they will be displayed here.
The choices are:-
o C/ o F/ o K
V, mV, A, mA
PH
mmHg, psi, bar, mbar, mmWg, inWg, inWW, PSIG
Ohms
%, %RH, %O2, %CO2, %CP,
PPM
Custom units are also possible
13-4 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00