model 2704 controller installation and operation handbook - Soliton

Alarm Operation
2704 Controller
7.9. ALARM PARAMETERS
The parameter tables listed in this section are only displayed if an alarm has been configured
for the particular loop, input or module.
7.9.1. ALARMS (LP1 Page) Parameters
Table Number:
7.9.1.
These parameters set up the Loop 1 alarms
ALARMS
(LP1) Page
Parameter Name Parameter Description Value Default Access
Level
Alm1 Type Alarm 1 Type Off
Full Scale Low
Full Scale
High
Deviation
Band
Deviation High
Deviation Low
Rate of
Change
If True
If False
Goes True
Goes False
If Changed
R/O
Alm1 Setpoint Alarm 1 Setpoint Controller
range
Alm1 Hyst Alarm 1 hysteresis Controller
range
Alm1 Output Alarm 1 output Off
On
Alm1 Inhibit Alarm 1 inhibit No
Yes
Alm2 Type Alarm 2 Type As Alm1 Type R/O
Alm2 Setpoint Alarm 2 Setpoint Controller
range
Alm2 Hyst Alarm 2 hysteresis Controller
range
Alm2 Output Alarm 2 output Off
On
Alm2 Inhibit Alarm 2 inhibit No
Yes
The above table is repeated for LP2 and LP3 if three control loops have been configured.
Off
No
Off
No
L1
L3
R/O
L3
L1
L3
R/O
L3
7-18 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00