model 2704 controller installation and operation handbook - Soliton

2704 Controller Module IO
18.3.6. PV Input
Table Number:
18.3.7.
This page allows you to set the parameters for
a PV Input module.
This module can only be fitted in slots 3 or 6.
MODULE IO
(Module 3(A)
Page)
Parameter Name Parameter Description Value Default Access
Level
Ident PV Input R/O
Electrical Lo Electrical low input level Input range L3.
Electrical Hi Electrical high input level units as
configured
See ‘To
Scale
Eng Value Lo Low display reading Display the PV
Eng Value Hi High display reading range Input’
Filter Time Input filter time Off to
0:10:00.0
Emissivity
Electrical Val
Module 3A (or 6A)
Val
Emissivity
Pyrometer input only
The current electrical value
of the input
The current value in
engineering units.
Module 3A can be a user
defined name.
Off to 1.00
Input range
units as
configured
Offset Transducer scale offset Display
range
Module Status Module status OK
Initialising
Ch A Sbreak
Ch A
OutRange
Ch A IP Sat
Ch A Not
Calib
CJC Temp
SBrk Trip Imp
Temperature read at the
rear terminals o C
Thermocouple inputs only
Current sensor break value
Read as a % of the SBrk
Impedance configured
L3
L3
R/O
R/O
0 L3
This module has a single input. Its parameters are displayed under ‘channel’ (A).
R/O
R/O
R/O
Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00 18-9