model 2704 controller installation and operation handbook - Soliton

Programmer Operation
2704 Controller
6.8.5. To Display Wait Status in Run Mode
The status of ’Wait’ is displayed in the ‘PROGRAM RUN’ page as follows:-
Do This
This Is The Display You
Should See
Additional Notes
1. Select ‘PROGRAM RUN
(General Page)
2. Press to show the
parameter list
3. Press or to
scroll to ‘Wait Status’
The status is off if not
waiting and true if waiting.
The choices are:-
No The program
Wait is not waiting
Event
A (B
or C)
The program
is waiting on
event A (B or
C)
4. Press to scroll to
‘Wait Condition’
Wait condition is the Wait
Event set up in each
segment, e.g. WaitA
means - ‘the event
causing a wait in this
segment’.
In ‘Hold’ this parameter
can be changed to ‘No
Wait’ to override a wait
condition.
The choices are:-
No Wait
Event A (B or C)
5. Press to select the
‘Wait Condition’
6. Press or to
override the condition (No
Wait), or to select a
different event (Event A, B
or C)
The condition can be
changed if the program is
in Hold
6-32 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00