model 2704 controller installation and operation handbook - Soliton

2704 Controller Getting Started
3.1. POWER UP
Install and wire up the controller in accordance with Chapter 2 and switch on. A short self
test sequence takes place during which the controller identification is displayed together with
the version number of software fitted.
3.1.1. The HOME Page
The controller then shows a default display, referred to as the HOME page. It is possible to
configure the HOME page to suit the preferences of the process or the user, but the format is
shown in Figure 3-1. This is also the default display on a new controller.
The HOME page will be displayed under the following conditions:-
1. When the controller is switched on
2. When the access mode is changed from configuration level to an operating level
3. When and are pressed together (see 3.10)
4. When a timeout (if configured) occurs
The HOME page can be configured as:-
1. Summary Page (see also Chapter 5)
2. The Program Run page (see also Chapter 6)
3. Loop Views - LP1 (as shown), LP2, LP3
4. The Access page (see Chapter 4)
5. Cycle Each Loop. LP1 to LP3 pages are cycled in turn
6. All Loops (summary of 2 or 3 loops if configured)
7. LP1, LP2, LP3 Trend Charts (PV & SP for each loop)
8. Program Mimic
The configuration of these displays is described in the Engineering manual, Part No.
HA026933.
Message Banner
Programmer
Status
Auto/Manual
Setpoint source
Output
PV
SP
Loop 1
Loop 2
Loop 3
Figure 3-1: The 'HOME' Page (default)
Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00 3-3