model 2704 controller installation and operation handbook - Soliton

Programmer Operation
2704 Controller
6.7.3. To Set Up Each Segment of a Program
Do This
1. From any display press
to access the page
header menu.
This Is The Display You
Should See
Additional Notes
2. Press or to
select ‘PROGRAM EDIT’
3. Press to show subheaders
4. Press or (if
necessary) to select
‘Segment’
4. Press to select the
segment parameters
5. Press or to
scroll up or down the list
of parameters.
6. Press again to
choose parameter.
If the program exists, the
segment details are displayed
If the program is new,
confirm as instructed on
the display
Create Prg: 2?
ªTCancel °TOK
After a few seconds or
when ª is pressed the
display goes to the
segment parameters .
Up to 100 segments are
available per program
The value or state of a
parameter prefixed by ! can
be changed using or
Tip - A back and forward scroll is available by holding down
or
respectively
and pressing
Further parameters may be accessed and adjusted in the same way. These are listed together
with an explanation of their function in the following table
.
6-20 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00
…