model 2704 controller installation and operation handbook - Soliton

Loop Set Up
2704 Controller
9.2.1. To Manually Set The PID And Other Tuning Parameters
Do This
1. From any display press
as many times as necessary
to access the page header
menu
2. Press or to select
‘LP1 SETUP’
This Is The Display You
Should See
Additional Notes
Alternatives are Loop 2
and Loop 3. These only
appear in the list if the
loops are configured.
Available at L3 but may
have been promoted to L1
or L2.
3. Press to display the
sub-headers
4. Press or to select
PID
3. Press to show the
parameter list.
4. Press or to
choose ‘Prop Band 1’
5. Press to select Prop
Band 1
6. Press or to set
the value of the
proportional band to be
stored in Set 1.
R/O. PID set 1 is only
displayed if gain
scheduling has been
enabled in configuration
level.
Shows the working PID
set based upon PV and
1/2 & 2/3 boundaries.
The choices are:
PID Set 1
PID Set 2
PID Set 3
The number Following
‘Prop Band’ shows the
gain set being edited
The proportional band can
be displayed in % or in
engineering units, and is
adjustable between 1 and
9999.9.
Note:
Text shown in italics is user definable in configuration
mode and may be different from that shown
Further parameters may be
set up in the same way.
These are listed together
with an explanation of their
function in the following
table
…
9-4 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00