model 2704 controller installation and operation handbook - Soliton

Standard IO
2704 Controller
To scale a linear PV Input proceed as follows:
Do This
1. From any display press
as many times as necessary
to access the page header
menu
This Is The Display You
Should See
Additional Notes
The PV Input is connected
to terminals VH, V+, V-.
2. Press or to select
‘STANDARD IO’
3. Press to show Subheaders
4. Press or to select
‘PV Input’ (if necessary)
5. Press to show
‘Electrical Lo’
6. Press again to select
‘Electrical Lo’
7. Press or to adjust
the value
Set this value to the
lowest level of the input,
eg 4mA.
The units displayed here
may be mV, V, mA or
Ohms depending on what
8. Press to select
‘Electrical Hi’
Set this value to the
highest level of the input ,
eg 20mA.
9. Press or to adjust
the value
[Units] If units have been selected in configuration level
they will be displayed here.
The choices are:-
o C/ o F/ o K
V, mV, A, mA
PH
mmHg, psi, bar, mbar, mmWg, inWg, inWW, PSIG
Ohms
%, %RH, %O2, %CO2, %CP,
PPM
Custom units are also possible
17-4 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00