model 2704 controller installation and operation handbook - Soliton

Input Operators
2704 Controller
11.2.2. Input Operator Custom Linearisation Parameters
Table Number:
11.2.2.
This page allows you to set up a customised
linearisation curve
INPUT OPERS
(Cust Lin 1)
Parameter Name Parameter Description Value Default Access
Level
Enable
Input Value
Output Value
Output Status
To enable custom
linearisation
The current value of the
input
The current value of the
output
The conditions are OK
The conditions are bad or
out of range
Off
On
Range
Range
Good
Bad
Input Lo Adjust to the low input value Range L3
Output Lo
Input Hi
Output Hi
Adjust to correspond to the
low input value
Adjust to the high input
value
Adjust to correspond to the
high input value
Range
Range
Range
Input 2 Adjust to the first break point Range L1
Output 2
Adjust to correspond to input
2
Range
The above two parameters are repeated for all intermediate break points, ie 2 to 14
Input 15 Adjust to the last break point Range L1
Output 15
Adjust to correspond to input
15
Range
Off
L3
R/O
R/O
R/O
L3
L3
L3
L1
L1
The above table is repeated for:
• INPUT OPERS (Cust Lin 2 Page)
• INPUT OPERS (Cust Lin 3 Page)
11-6 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00