model 2704 controller installation and operation handbook - Soliton

Programmer Operation
2704 Controller
6.6.4. From the Programmer Run Parameters Page
To Run, Hold or Reset a program from the Programmer Run page:-
Do This
This Is The Display You
Should See
Additional Notes
1. From any display press
to access the page
header menu.
2. Press or to
select ‘PROGRAM RUN’
3. Press to show subheaders
4. Press or (if
necessary) to select
‘General’
5. Press to select the
list of parameters for
running the program.
6. If the Program Number is
correct and Fast Run is
not required, press to
scroll to ‘Program
Status’
Shows the current status
of the program
The choices are:-
Run see 6.2.1
Hold see 6.2.2
Reset see 6.2.3
7. Press or to
select R n
Warning!
Fast run allows the program to be tested by quickly running
through the program segments. If the controller is
connected to the process, ensure that the process is not
affected if fast run is selected.
The default value, No, means that the program will run at
the set rate
6-14 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00