model 2704 controller installation and operation handbook - Soliton

Programmer Operation
2704 Controller
Wait Status Wait Status No Wait
Event A
Event B
Event C
Wait Condition
Wait condition for the running
segment
No Wait
Event A
Event B
Event C
No Wait
R/O
No Wait L1.
Alterable in
Hold
Prog User Val 1 Active Programmer User Val 1 L1
Prog User Val 2 Active Programmer User Val 2 L1
Goback Rem Number of repeat cycles
remaining
1 to 999 R/O
End Action
Prog Reset DO
The state required in the end
segment
These are the digital events in
Reset
æ æ æ æ
Dwell
Reset
Reset UsrVal1 Reset prog user 1 values L3
Reset UsrVal1 Reset prog user 1 values L3
R/O
R/O
Only if
configured.
Table Number:
6.6.5b
These parameters are associated with
Profiled Setpoint number 1
PROGRAM RUN
(PSP1 Page)
Parameter Name Parameter Description Value Default Access
Level
Seg Time Rem Segment time remaining h: m: s
PSP1 Type
PSP1 WSP
Running segment type for
profiled setpoint 1
Working setpoint for profiled
setpoint 1
Step
Dwell
Ramp
Display
range 1
R/O - shown
in Ramp
Rate prog.
L1. Alterable
in Hold
PSP1 Target
Running segment target for
profiled setpoint 1
Display
range 1
L1. Alterable
in Hold
PSP1 Dwell Tm
Time remaining in running
segment for profiled SP 1
Display
range
L1. Alterable
in Hold
PSP1 Rate
Running segment rate for
profiled setpoint 1
Display
range 1
L1. Not in
Time To
Target prog
PSP1 HBk Appl
Holdback applied for profiled
setpoint 1
No
Yes
R/O - shown
if configured
1. Range limited by user defined upper and lower limits
Table 6.6.5b is repeated for PSP2 parameters and PSP3 parameters
6-16 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00