model 2704 controller installation and operation handbook - Soliton

Input Operators
2704 Controller
11.3.2. Input Operators Switch Over Parameters
Table Number:
11.3.2.
This page allows you to set up and inspect
Switch Over parameters
INPUT OPERS
(Switch 1 Page)
Parameter Name Parameter Description Value Default Access
Level
Switch Lo
Switch Hi
PV = Input 1 below this
value
Can be adjusted up to the
limit set by ‘Input Lo’ in
configuration level or the
limit set by ‘Switch Hi’
PV = Input 2 above this
value
Can be adjusted up to the
limit set by ‘Input Hi’ in
configuration level or the
limit set by ‘Switch Lo’
Display Range
Display Range
Output Value The current working value Display Range R/O
Output Status
Input 1 Value
Input 1 Status
Input 2 Value
Input 2 Status
The conditions are OK
The conditions are bad or
out of range
The current working value
Can be adjusted between
the limits set by ‘Input Lo’
and ‘Input Hi’ in
configuration level
The conditions are correct
The conditions are bad or
out of range
The current working value
Can be adjusted between
the limits set by ‘Input Lo’
and ‘Input Hi’ in
configuration level
The conditions are correct
The conditions are bad or
out of range
Good
Bad
Display Range
Good
Bad
Display Range
Good
Bad
L3
L3
R/O
R/O
R/O
R/O
R/O
11-10 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00