model 2704 controller installation and operation handbook - Soliton

Getting Started 2704 Controller
3.2. THE OPERATOR BUTTONS
AUTO LOOP PROG
AUTO
LOOP
Auto/Manual
button
Loop select
button
Programmer
button
When pressed, this toggles between automatic and
manual mode:
• If the controller is in automatic mode ‘AUT’ is displayed
• If the controller is in manual mode, ‘MAN’ is displayed
See Figure 3-1
Each press selects each loop in turn or between each
loop and the trend chart if each of the above options are
configured plus a summary of all loops.
The loop name is shown in the banner at the top of the
display
• Press once to display a pop up window
PROG
This button
operates the
programmer
on all loops
See also
Chapter 6
‘Programmer
Operation’
The pop up window will remain for approximately 6
seconds and during this period:-
• Press PROG again to RUN a program
• Press PROG again to HOLD a program
• Press PROG again to toggle between RUN & HOLD
Page button
Scroll button
Down button
Up button
• Press PROG and hold for two seconds to reset
Press to select new pages from the page header ‘Menu’.
If held down it will continuously scroll the pages.
Press to select a new parameter from the page heading.
If held down it will continuously scroll through the
parameters.
Press to decrease an analogue value, or to change the
state of a digital value
Press to increase an analogue value, or to change the
state of a digital value
Note:- The AUTO, LOOP, or PROG may have been disabled in configuration level.
Figure 3-2: Operator Buttons
3-4 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00