model 2704 controller installation and operation handbook - Soliton

Programmer Operation
2704 Controller
6.8.2. To Enter a Program in a Time to Target Programmer
This is the same as the previous procedure except that there are no Dwell, Rate or Step PSPs.
They are all TimePSPs.
Steps 1 to 10 shown in the Ramp Rate example are the same for the Time to Target
programmer. From the PROGRAM EDIT (Segment Page) parameters:-
Do This
This Is The Display You
Should See
Additional Notes
11. Press to select ‘PSP1
Target’
12. Press or to set the
target level of the segment
eg 100
13. Press to scroll to ‘Seg
Duration’
14. Press or to set the
target level of the segment
eg 0:01:00
For any segment _ 1, this
value will normally be
inherited from the Target
level of the previous
segment.
The setpoint will ramp to
100 at the rate of 1 unit
per sec, min or hour
As in the previous
example, if PSP2, PSP3,
Wait Events and Event
Outputs have been
configured they will
appear here.
For a ramp set PSP-
Target to a new value
For a dwell set PSP- to
the previous value.
Repeat the procedure until all segments have been set up. The last segment should be
defined as ‘Segment Type = End Segment’.
Tip - There are two ways to return to a previous parameter in a list.
1. A back and forward scroll is available by holding down and pressing or
respectively
2. Press once and use the or button
6-28 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00