model 2704 controller installation and operation handbook - Soliton

Analogue Operators
2704 Controller
14.2. TO VIEW AND ADJUST ANALOGUE OPERATOR
PARAMETERS
Do This
1. From any display press
as many times as necessary
to access the page header
menu
This Is The Display You
Should See
Additional Notes
2. Press or to select
‘ANALOGUE OPERS’
3. Press to show Subheaders
4. Press or to
select ‘An 1 (to 24)’
5. Press to show the
parameter list
6. Press to highlight
‘Input 1 Scalar’
This is a read only parameter
available in Access Level 1
(provided the page has been
promoted to this level). It
displays the type of
calculation which has been
configured.
The choices are:
Off, Add, Subtract, Multiply,
Divide, Absolute Difference,
Select Max, Select Min, Hot
Swap, Sample Hold, Square
Root, Log, Ln, Exp, 10x,
Select Logic 1 to Select Logic
32.
This scalar is used as a
multiplying factor on input 1
7. Press again to select
‘Input 1 Scalar’
8. Press or to
change the value
14-4 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00