model 2704 controller installation and operation handbook - Soliton

2704 Controller Getting Started
3.11. DISPLAYS FOR CASCADE, RATIO AND OVERRIDE
The Loop Summary, displayed in previous views in this chapter, shows a controller
configured as ‘Single’ loop. The Loop Summary view, for controllers configured as cascade,
ratio, override or valve position varies as shown in this section.
For more information on these methods of control see Chapter 9.
Target Output Power
Master PV
Master SP
Slave PV
Slave SP
This line may show different parameters
Press to show alternatives. The defaults are:
Target Setpoint The main SP Press
Target OP Output demand
VPos
Valve position (VP controller
only)
or
Local SP
Disable CSD
Local (Slave) setpoint
Allows cascade to be turned off
eg for commissioning purposes
to adjust
the value.
Note:
1. The parameter displayed first depends upon other settings.
For example; if controller is in Auto the Target SP is displayed
first; if the controller is in Manual the Target OP is displayed
first.
2. In configuration level it is possible to hide or make individual
parameters read only.
Figure 3-8: Cascade Loop View
Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00 3-15