model 2704 controller installation and operation handbook - Soliton

Digital Programmer
2704 Controller
6A.1.4.
Digital Program 1 to 4 Page
Table Number:
6A.1.4.
These parameters are associated with
Digital Programs 1 to 4
DIGITAL PROG
(Dig Prog x Page)
Parameter Name Parameter Description Value Default Access
Level
Reset Disable Reset Off
On
Run/Hold Run or hold Off
On
OP Enable Enables the output Off
On
Reset on PFail Power fail response Off
On
Program Cycle
Number of cycles for the
sequence
Continuous
to 999
Seg Time Rem Segment time remaining 0:00:00.0
to
99:59:59.9
Output
Output (Inv)
Prg End
Shows the current state of
the output
Shows the current inverted
state of the output
Program complete
Off = prog running`
On = prog complete
Off
On
Off
On
Off
On
Off
Off
Off
Off
Continuous
L1
L1
L1
L3
L1
L1
L1
L1
L1 R/O
6A.2. POWER FAIL RECOVERY
In the event of a power fail to the controller, a parameter, ‘Reset on Pfail’, may be set in
configuration level which defines how the controller behaves on restoration of the power.
If this parameter = ‘On’ then ‘Run/Hold’ =’Off’ and ‘Reset Disable’ = ‘Off’ at power up.
If Run/Hold and Reset Disable have been soft wired in configuration level they override this
state.
6A-6 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00