model 2704 controller installation and operation handbook - Soliton

Getting Started 2704 Controller
3.10. PARAMETER TABLES
Subsequent chapters in this manual refer to parameter tables. These tables provide the full
list of parameters available at Access Level 3 in a particular page. The table below is an
example.
Column 1 gives the name of the parameter as it appears on the display.
Column 2 is a description and possible usage of the parameter
Column 3 is the range of values which can be set. . This may be a numerical value, eg -n
to +n, or the condition (enumeration) of a parameter, eg the parameter ‘Program
Status’ has enumerations ‘Run’, ‘Hold’, ‘Reset’.
Column 4 is the default value (if applicable) of the parameter set during manufacture
Column 5 is the access level required to change the parameter value.
L1 means that the value is only shown in Level 1
L2 means that the value is only shown in Level 1 and Level 2
L3 means that the value is always available in the instrument operating mode
(i.e. not Configuration Level)
R/O is Read Only
Access Levels are described in Chapter 4.
For Configuration Level access see 2704 Engineering Manual, Part Number HA
026933
Table Number: Description of the page Page
Header
1
Parameter Name
2
Parameter Description
3
Value
4
Default
5
Access
Level
Program Number The number of the selected program L3
Segment Number The currently running segment
number
L3
PSP1 Type Program Setpoint 1 type L3
PSP1 Working SP Program Setpoint 1 working setpoint L3
PSP1 Target Program Setpoint 1 target setpoint L3
PSP1 Dwell Time Program Setpoint 1 dwell time L3
This is a continuous loop which returns to the list header
Note:-
A parameter only appears if it is relevant to the configuration of the controller. For
example, a programmer configured as Time to Target will not display the Rate
parameter.
3-14 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00