model 2704 controller installation and operation handbook - Soliton

Getting Started 2704 Controller
3.9. PARAMETER VALUES
Parameter values can be displayed in different ways depending upon the parameter type. The
different types of parameter, and how their values are changed, are shown below.
1. Numerical Values (eg Full Scale High Alarm Setpoint)
FS Hi Setpoint !200
Press
Press
to increase the value
to decrease the value
2. Enumerated Values (eg PV Input Alarm Acknowledge)
PV Alm Ack
!No
Press
Press
to show next state
to show previous state
3. Digital Values (e.g. programmer event outputs)
Prog Reset DO ! æ
Press to step along the values. A cursor under
the selected value flashes.
4. Parameter Addresses (eg PV Src )
Press or to turn the value on or off
PV Src !05108:PVIn.Val
Press or to change the Parameter address.
A cursor under the parameter address flashes.
The parameter name for that address (if it exists) is
shown to the right of the Modbus address.
Press
to change from parameter address to parameter mnemonic
PV Src !05108:PVIn.Val
Press or to change the parameter address by
scrolling through a list of the most popular mnemonics.
A cursor under the parameter mnemonic flashes.
Note:- This example is only available in configuration level, but is included here to illustrate
the principle of operation.
3-12 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00