model 2704 controller installation and operation handbook - Soliton

2704 Controller Standard IO
17.3. ANALOGUE INPUT
Allows access to parameters which set up the fixed Analogue Input connected to terminals
BA, BB and BC. This is the high level input from a remote source.
17.3.1. To Scale the Analogue Input
The procedure is the same as that described in section 17.2.1.
17.3.2. Standard IO Analogue Input Parameters
Table Number:
17.3.2.
This page allows you to set up Analogue Input
Parameters
STANDARD IO
(An Input
Page)
Parameter Name Parameter Description Value Default Access
Level
Electrical Lo Electrical low input level Input range L3
Electrical Hi Electrical high input level Input range L3
Eng Value Lo Low display reading Display
range
Eng Value Hi High display reading Display
range
Filter Time Analogue input filter time !Off to
0:10:00.0
Electrical Value
An Input Val
An Input can be a
user defined
name.
Offset
The current electrical value
of the analogue input
The current value of the An
Input in engineering units
Transducer scaling offset.
Only appears if the PV input
is configured for transducer
Input range
Display
range
Display
range
An In Status Analogue input status Good
Bad
SBrk Trip Imp Sensor break value Display
range
æ
L3
L3
L3
R/O
R/O
L3 R/O
L3 R/O
L3 R/O
Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00 17-7