model 2704 controller installation and operation handbook - Soliton

2704 Controller Programmer Operation
6.6. TO RUN, HOLD OR RESET A PROGRAM
There are four ways to control the status of a program as follows:
6.6.1. From the ‘PROG’ Button
6.6.1.1. To Run a Program
If the program is in Reset mode, press the ‘PROG’ button once. A pop up window is
displayed:
Press the PROG button again to select ‘Run’
The symbol in the top left of the display changes to
6.6.1.2. To Hold a Program
A program can only be held from Run mode. Press the ‘PROG’ button once. The pop up
window is again displayed showing ‘Run’. Press the ‘PROG’ button again. The message in
the pop up window changes to ‘Hold’.
The symbol in the top left of the display changes to.
6.6.1.3. To Reset a Program
Press the ‘PROG’ button once. The pop up window is again displayed showing ‘Run’ or
‘Hold’. Press the ‘PROG’ button again and hold it pressed for 2 seconds. The message
changes to ‘Reset’.
The symbol in the top left of the display changes to
6.6.2. From Digital Inputs
If digital inputs have been configured and wired for an external RUN, HOLD or RESET,
activate the relevant digital input. This will normally be activated from an external switch.
6.6.3. From Digital Communications
If a PC running SCADA package or iTools is connected to the controller via the digital
communications module, the programmer status may be changed from this package.
Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00 6-13