model 2704 controller installation and operation handbook - Soliton

2704 Controller Input Operators
11.3.1. To Set Up Thermocouple/Pyrometer Switching Points
Do This
1. From any display press
as many times as necessary
to access the page header
menu
This Is The Display You
Should See
Additional Notes
2. Press or to select
‘INPUT OPERS’
3. Press to show Subheaders
4. Press or to
scroll to ‘Switch 1’
5. Press to show the
parameter list
6. Press again to select
‘Switch Lo’
The Process Value used
by the controller is derived
from Input 1when it is
below the value set on the
display
7. Press or to
change the value
8. Press to select
Switch Hi
9. Press or to
change the value
The Process Value used
by the controller is derived
from Input 2 when it is
above the value set on the
display.
The transition between
Input 1 and Input 2 is
determined by the Switch
Over algorithm
The following table gives the full list of parameters available under this list header
…
Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00 11-9