model 2704 controller installation and operation handbook - Soliton

Logic Operators
2704 Controller
7. Press to select Input
2 Value
This is a read only value,
Off or On.
8. Press to select
Output Value
This is a read only value
of the result of the
calculation,
Off or On.
9. Press to select
Status
The result of the
calculation is Good or
Bad.
An example of a bad
status may occur if a
sensor break condition is
detected.
The output will default to a
‘fallback’ value previously
set in configuration level.
This is described in the
Engineering Handbook,
Part No. HA026933.
15-4 Installation and Operation Handbook. Part No HA026502 Issue 1.0 Apr-00