Jeep Engines - Oljeep

324 MOPAR PERFORMANCE PARTS24. To supply a switched 12 volt power supply to the twobulkhead mounted relays, locate the old positive (+)side coil wire (usually a yellow color). Connect thiswire to the relay wire. Now connect the red relay wireto the starter relay, battery plus (+). The starter relay(also known as the starter solenoid) is usually locatedunder the battery box or mounted on the fender panel.Mount the system fuse.Note: Make sure that the switched 12 volt wire is notrouted through a ballast resistor or resistance wire.Also make sure that 12 volts are present on this wireduring cranking!25. Install the 7.5 amp diode (supplied) in the field wire ofthe alternator. This is the smaller of the two wires,usually brown in color, that plugs into the alternator.Note-the field wire is a solid wire not a stranded wire.Cut the wire and install the diode with the pink crimponconnector facing toward the alternator. It isimperative that this diode be in the field circuit toprotect the new electronics.26. You may wish to install a new windshield washerbottle and bracket. These can be obtained through yourlocal JeepEagle dealer. Washer bottle part number is55 154744; bracket is 55026288. This washer bottleand bracket are supplied with this kit. You can mountthis anywhere you would like, but the correct place tomount it is on the back side of the driver’s side fenderwell. The fit is very tight but it does fit.27. Install the new air filter and bracket. It attaches to thedriver’s side body support rod. Connect the two 1/2”hoses, from the aluminum connectors, to the valvecover vent and the fuel canister vent line. Note-thelarge flexible intake hose can be cut off to the lengthyou need. In some vehicles, this flexible (CAT) hose istoo long.Figure 5 - 26