Jeep Engines - Oljeep

360 AMC V-8 (INTRODUCTION) 375Note: The following procedures for the 360 AMC V-8 engine are intended to be performed in-vehicle, on a dynamometer,or as an individual change/modification.In addition to the information contained in this chapter, much of the information contained in Chapter 4, 4.0L Power Tech Zn-Line 6, is generic to all Jeep engines (including the 360 AMC V-8). Therefore, in addition to this chapter, we highlyrecommend that all 360 AMC V-8 engine owners read Chapter 4 in its entirety.For additional 360 AMC V-8 engine general service informal.ion, refer to the proper service manual.Note: The AMC-built 360 V-8 engine is NOT related toeither the DaimlerChrysler small block 360 'A' engine or5.2L Magnum engine. For complete information on theDaimlerChrysler 'A' engine family, refer to Small Block 'A 'Engines (P4876826). For complete information on theDaimlerChrysler Magnum engine family, refer to MagnumEngines (P4876668).The AMC-built 360 CID engine is a cast iron, 8 cylinder,90" V-block design that was in production from 1970-9 1. Ithas a standard bore and stroke of 103.63 x 87.38 mm (4.08x 3.44"), and an 8.25:l compression ratio.IntroductionAMC-built V-8 engines also came in the following CIDversions:Enaine CID [Year)Bore x Stroke290 (1966-69) 3.75 x 3.28"304 (1 972-80) 3.75 x 3.44"343 (1 967-69) 4.08 x 3.28"360 (1 970-9 1) 4.08 x 3.44"390 (1 968-70) 4.165 x 3.514"401 (1973-79) 4.17 x 3.68"Engine Description, CylinderIType ................................................Bore ond Stroke .........................................Displacement ...........................................Compression Ratio ........................................Torque ..............................................Firing Order.. .........................................lubrication ............................................Engine Oil Capacity. ......................................Cooling System. .........................................Cooling System Capacity ...................................Cylinder Block ..........................................Crankshaft ............................................Head ..........................................Camshaft ............................................Pistons .............................................Pistons Combustion Cavity ...................................Connecting Rods ........................................8 cylinder 9 P V-Block103.63 x 87.38 mm (4.08 x 3.44 in)5.9L (360 cu. inch)8.25:i379 N.m (280 ft-lbs) @ 1500 rpm1-8-4-3-6-5-7-2Pressure Feed-Full Flow Filtration4.7L (5 Quarts)Liquid Cooled-Forced Circulation13.2L (14 Quarts)Cast IronCast Nodular IronCast IronCast IronAluminum Alloy (with Struts)Open ChamberCast IronJ8909-40 3