Jeep Engines - Oljeep

444 MOPAR PERFORMANCE PARTS1990,360 AMC V-8 ENGINE SPECIFICATIONSNote: The following information has been reprinted from the 1990 Jeep Service Manual.Type. ................................................No. of Cylinders ............................................Bore. .......................................................90" V-BlockB103.63 mm 4.08 in.Stroke .......................................................Displacement .................................................Compression Ratio ............................................Compression Pressure (Minimum) ................................Maximum Variation Between Cylinders. ........................ComshaftFuel Pump Eccentric Diameter.. ...............................Tappet Clearance ...........................................End Play.. .................................................Bearing Clearonce ..........................................Preferred. ................................................Crankshaft Bearing Journal DiometerNo. 1.. .......No. 2.. ................ ...........................No. 3.. ............................ ................No. 4.. ...... ............................No. 5.. ................... .........................Maximum Base Circle Runout.. ..............87.:38 mm5.9 liter8.25:l827-1 034 kPa206 kPa55.423-55.677 mmZero lash (hydraulic tappets)Zero (engine operating)0.0254-0.0762 mm0.01432-0.0508 mm53.835-53.861 mm53.073-53.099 mm52.31 1-52.337 mm51.549-51.575 mm50.787-50.81 3 mm0.0254 mm3.44 in.360 cu. in.120-1 40 psi30 psi2.1 82-2.1 92 in.0.001 -0.003 in.0.001 7-0.002 in.2.1 195-2.1 205 in.2.0895-2.0905 in.2.0595-2.0605 in.2.0295-2.0305 in.1.9995-2.0005 in.0.001 in.Corn Lobe Lift.. ...........................................Intake Valve TimingOpens ...................................................Closes ...................................................Exhaust Valve TimingOpens .....................................................Closes .....................................................Valve Overlap.. ..............................................lntoke Duration ...............................................Exhaust Duration. .............................................6.7564 mm 0.266 in.14.75" BTDC68.75" BTDC56.75" BBDC261.75" ATDC41.5"263.5"263.5"Connecting RodsTotal Weight (Less Bearings). ..........................Total Length (Center-to-Center).... ..................Bearing Clearance ..............................Preferred. ......................... ................Side Clearance ........................ ............Maximum Twist (per in.). ...... ................Maximum Bend (per in.). .................... ..........681 -689 grams149.1 7-1 49.28 mm0.03-0.08 mm0.051 -0.064 mm0.1 5-0.46 mm0.01 3 mm0.03 mm24.0-24.3 02.5,873-5.877 in.0.001 -0.003 in.0.002-0.0025 in.0.006-0.01 8 in.0.0005 in.0.001 in.J8909-4t