V6 User Manual 1.00.book - Studio General

In 3 point editing, the “virtual” missing gate of the group that has only one gate set is displayed in Grey.Set the Cursor to the selected Track Group Gate In/OutCursor & Marks > Cursor to Gate In/OutZoom to the selected Track Group Gate In/Out.Cursor & Marks > Show Gate In/OutNudge the selected Track Group Gate In/Out with the menu selectionCursor & Marks > Nudge Gates > Nudge Gate In/Out to Left/Right.Each nudge operation can be auditioned automatically by setting 'Auditionafter Nudge' in the Settings > All Settings > Application > Editing pageAudition the selected Track Group Gate In/Out Pre/Through/Post with themenu selection: Machines > Internal Machine > Audition > Audition Gate In/OutPre/Audition/Post.The space between Gate In and Gate Out can be selected with the menuSelection > Select between Gates.Positions of Gate In and Gate Out for each selected groups can be displayed and manually modified with theSource-Destination Toolbar (If not already visible show with View > Scales > Toolbars > Source-Destination)Once Gates In and Out have been set, Source - Destination operations can be applied FROM either the selectedSource Track Group or the last Source Track Group whose Gates have been set TO either the selected DestinationTrack Group or the last Destination Track Group whose Gates have been set.Both Source and Destination Gate In and Gate Out can be set or removed(by setting them twice at the same position) to perform any combination of Source - Destination editing operationdescribed in the table below.When Gates are set the following Source-Destination operations available in the Edit menu can be applied:• Auto-Edit Source to Destination• Overwrite Source to Destination• Insert Source to Destination• Replace Source to Destination• Fit Source to DestinationWhen the Source has only 1 Gate then the region to edit can be automatically adjusted to the end (or beginning incase of a single Gate Out) of the clip under the Gate when the edit operation is performed. This is available bychoosing the menu item:Edit > Source – Destination Settings > Limit 1 Gate Sources to End/Beginning of clip.When the Source has 2 Gates set and the Destination has 1 Gate set, then the behavior of the Auto-Edit Source toDestination operation can be chosen between Overwrite or Insert by choosing the menu item:Edit > Source- Destination Settings > 3 Gates Auto-Edit does Overwrite/InsertThe menu item:Edit > Source - Destination Settings > Auto Set Destination Gate In after Editallows the Destination Gate In to be set to the previous Destination Out point after any Source-Destination operation.This automatically prepares the Destination for the next operation. The Destination is also automatically centeredaround the new Gate In.Editing : Source - Destination Editing 8 - 133