V6 User Manual 1.00.book - Studio General

converted properly. In Settings > All Settings > Hardware > I/O Interfaces, the I/O interface page correspondingto each AES II daughter card in the system shows an array like this:Up to 192 kHz, each column represents one XLR connector (one pair of channels) with its associated SRC chip.The following configurations can be selected:AES II Settings• None: or bypass, the SRC is transparent• Input: The SRC works on the input path and converts the incoming signal to the project's sampling rate• Ref1/2 through Ref 7/8: The SRC is inserted in the output path and converts the output signal to the samplingrate of the signal present at the input chosen as reference.At 8FS (DXD/DSD), the AES II daughter card has a special mode that is enabled by selecting 8FS to nFS in theSpeed on physical wire field of the I/O interface page. This mode provides a fixed set of 2 input and 2 outputpaths and enables a real-time conversion from 384kHz/352.8kHz down to 192kHz/44.1kHz and vice-versa. OnlyXLRs 1/2 and 3/4 are used in this mode. For the outputs, the reference input for the sampling frequency is selectablein the "Sampling Rate Converters" array.AES II SettingsAppendices : Appendix II I/O Daughter-card Options 29 - 563