V6 User Manual 1.00.book - Studio General

Basic StripA basic mono channel strip contains:On /Off toggle switchPan slider to Main output bus. In this case there is just a single stereo mix bus.Basic StripNumeric display of fader output level value, if cursor is over a fader knob shows fadergain. If cursor is over pan-slider, shows current pan position. May be clicked to directlyenter a fader gain value.Level Bargraph Rotary Controls and FadersRotary Controls, sliders and Faders may be adjusted by grabbing them with the mouseand dragging. Rotary controls and horizontal sliders are adjusted by dragging left or rightand faders by dragging up or down. Double-clicking a Fader or Rotary knob returns thevalue to the default. E.g. unity gain on a channel strip fader. Bargraph shows peak levelButtonsButtons on the main mixer surface are black when inactive. When active they ‘light up’.Solo solos the strip, Mute mutes the strip Ctrl + Solo cancels all other SolosSAFE prevents the strip being muted by solo operations elsewhere. Ø reverses the channelphase. PF changes the metering position to Pre-Fader.Delay A delay value (in samples) can be set in this box.Input Clicking on Input pops-up a box with the choice of the strip taking its input from aphysical connection or any output bus.Logical Input and Direct Output AssignmentRight-click on the XLR icons to pop-up a drop down list of valid assignments.Note: Direct Outputs must first be enabled in the Configure page.Please see: Channel Direct Outputs on page 164Stereo StripsIn a Stereo Strip feeding a stereo bus the single bargraph meter is replaced by a pair and the simple pan pot isreplaced by a choice of Balance control, Dual Panner, Pan/Width or 5.x Legacy Stereo Panner accessible fromthe right-click context menu. (See below)Stereo Strips can reverse the Phase of both the Left and Right channels. The single button has four possible states:Black:White:Red:Blue:No phase inversionLeft channel invertedRight channel invertedBoth channels invertedMixer : Mixer Components 10 - 171