V6 User Manual 1.00.book - Studio General

Saving SettingsFx In• All input strips• All VS3 plug-ins inserted on Input strips• All active Input connectionsFx-INs can be spread across multiple DSP cards (since no summing is required at this stage).Please see: Allocating DSP on page 440 for some tips on appropriate DSP allocationIf you change any settings for a given application then clicking on Apply opens the Save Configuration dialog :Click on Yes to saveRoutingSince V5 the routing functionality has been removed from the VS3 Control panel and is now more convenientlyaccessed via Settings > All Settings > Hardware > Routing in the main Pyramix application.Appendix IV - HDTDM v XDTDM v MassCoreInternal Bussing & I/O CapabilitiesHDTDM mode offers a maximum of 64 busesXDTDM mode offers a maximum of 128 busesMassCore mode offers a maximum of 384 busesIn the upgrade from Pyramix V4 to V5, the number of channels was doubled. The inter-board bus was enhancedin terms of bandwidth and renamed the XDTDM bus, for eXtreme Definition Time Domain Multiplex. Someexceptions exist and these are discussed below.Note: The HDTDM, XDTDM and MassCore bussing modes are selected in the VS3 ControlPanel Please see: Appendix III VS3 Control Panel on page 566In the upgrade from Pyramix V5 to V6 MassCore was introduced. This multiplies all mix engine processing andallows for higher bussing capabilities.Appendices : Appendix IV - HDTDM v XDTDM v MassCore 29 - 571