V6 User Manual 1.00.book - Studio General

SRC In 1Setting: InputXLR 1/2ADC44.1kHzSync: InternalDXD ProjectAES II SRCSRC Out 1Setting: Ref 1/2XLR 3/4DAC44.1kHzSync: InternalSync: InternalSpeed on physical wire:8FS to nFSSRC 5/6Setting: InputXLR 5/6SRC 7/8Setting: Ref 5/6XLR 7/8Effect Box96kHzSync: InternalExample 3: 2 channels 44.1 kHz AD/DA and 96 kHz effect box insert in a 192 kHz projectDual DC I/OThe Dual DC offers up to 12 inputs and outputs at 32kHz, 44.1kHz or 48kHz sampling rates on a single board. Allconverters are 24 bit. Connection is via 2 DB-25 connectors. One, on the main card attached to the Mykerinos, carriesthe analog I/O and the second, on a separate bracket, carries four AES/EBU Input and Output stereo pairs.There are four analogue Line outputs and four analogue Line Inputs, two of which may be switched to accept Micor Line level inputs. These have Mic pre-amps and 48V phantom powering. The analogue Line level I/O is adjustableover a 24dB range to accommodate all standard studio levels. Optional break-out cables can be ordered separatelywhich connect to the DB-25 connectors and terminate in 8 XLR connectors.The Dual DC is the most cost-effective I/O daughter card for Pyramix users. It is an ideal I/O solution for mixed analog/digitalrequirements, as encountered in Broadcast production, and Video post-production environments. Itallows direct connection of up to two dynamic or condenser microphones, typically for quick and easy voice-overrecording.Note: the Dual DC I/O daughtercard is not HDTDM bus compatible and can not be usedin a multiboard setup.MADI I/OThe MADI daughter card offers 56 channels of 24 bit bi-directional I/O, and up to 64 channels in MADI-X (MADIExtended) format. It can be ordered either in a BNC coaxial version or an optical duplex SC version. Both versionsare fitted with a standard Wordclock BNC I/O connector, which can be programmed in the Pyramix software as aWordclock In or Out signal.SDIF I/OThe Mykerinos SDIF daughter board is specially designed for multi-track DSD recording. It offers 8 channels of DSDdigital input over 8 unbalanced, 75 Ohm terminated BNC connectors and 8 channels of DSD digital output over 8unbalanced, 75 Ohm BNC connectors.One channel of DSD signal is transported at the bit-rate of 2.82 MHz througheach BNC connector. SDIF-2 and SDIF-3 format are fully supported for DSD transport (selected under softwarecontrol)Note: With one Mykerinos board, it is only possible to use one DSD Input and Outputchannel. To have the full range of 8 I/O channels, either MassCore or a second Mykerinosboard is required to provide sufficient DSP power.Appendices : Appendix II I/O Daughter-card Options 29 - 565