V6 User Manual 1.00.book - Studio General

• Set all desired tracks in Auto-Punch mode• Place Mark In at 00:00:00:00 and Mark Out at 23:59:59:24 (These are the default values for a new project)• Plug LTC Out from the tape machine into Pyramix• Set Chase mode to HARD CHASE (Settings > All Settings > Jog/Chase : Chase Settings -Chase Mode)• Rewind the tape• Press Play on the tape machine• Each time a valid TC is encountered Pyramix will lock and start recording a new clip, then stop when theTimeCode jumps. A separate media will thus be created for each continuous TimeCode on the tape.Loop Recording With Simultaneous Playlist Creation• Check the Create an Empty Playlist for each Recording option in the Settings > All Settings Project >Record Page.• Put the required tracks in Auto Punch mode (Alt + click the track arming, the track arming button will display)• Place Mark In and Mark Out around the region to be recorded.• Put Pyramix in Chase Mode (preferably Hard Chase) and chase an LTC input.• Have the TimeCode that feeds Pyramix looping around two boundaries that start a little before the MarkIn and stop a little after the Mark out. (To make a Preroll Postroll. These should be big enough to let Pyramixsync properly and lock to the incoming TimeCode).• Pyramix will then, for each loop, sync and lock, enter in record at Mark In, stop recording at Mark Out andcreate a new PlayList for each loop iteration.N.B. This requires that an external TimeCode source/generator be used to generate the reference TC loop.TimeCode MidnightFor those users with a requirement to sync/chase TimeCode with projects near or crossing the day barrier (be itZero or 24 hours) Pyramix has an Allow chasing across midnight option in the Settings > All Settings > Application> Jog/Chase page.If this setting remains unchecked (default) then the Pyramix cursor will always follow the exact given TimeCodeand therefore will remain strictly within "day zero" of the Pyramix timeline. For additional security and comfort, ifPyramix is in locked state while crossing the midnight barrier, then even with this setting unchecked, there willnot be an immediate jump from midnight back to zero while playing or recording in sync. The playback or recordingwill remain seamless, uninterrupted and cross the day barrier until an out-of-lock status is recognized. Onlythen is re-chase triggered to whatever the incoming TimeCode currently is.Editing Multitrack RecordingsTo edit Multitrack recordings without listening to all of them just Mute the tracks and Hide them. All edits performedon the remaining visible one will still occur on all others and only the audio from the visible one will beplayed back for monitoring. (E.g. a stereo guide mix)Film 24 to NTSC SyncHere are some settings for the most common Scenarios for Film 24 to NTSC Sync. Presets for all of these can befound in Settings > All Settings > Hardware > Formats & Sync.Applications : Loop Recording With Simultaneous Playlist Creation 19 - 347