V6 User Manual 1.00.book - Studio General

Drop down list menu:Offers the choice of Full Delay Compensation, All but effects latencies and Off.Please see: Mixer Delay Compensation on page 177Mixer Configuration SummariesThe two panels at bottom right summarize the current mixer configuration. Input Strip Summary lists the totalnumber of Channels and Input Strips and the quantity of each type. Buses / Masters Summary lists the totalnumber of bus channels and buses strips with the quantity of each type.Note: Rebuilding a large mixer with many effects can take some time.Click and drag the separator bar between Strips and buses to show more or less buses. The scroll bars give accessto strips currently off screen.Direct OutputsThe Direct Out connection is disabled by default. It can be enabled in the Configuration Page by selecting thestrip and clicking on the DO: Off box or disabled if the box shows DO: On. Alternatively Direct Out can be set inthe Route Page by clicking on the Strip Header.The Direct Out can be routed by Channel to any output of the HDTDM or XDTDM bus. The Direct Out can be sentPre or Post Fader. Click on the DO: Post box in the Mixer I/O section to toggle. The Direct Out is currently alwaysPost Effects. For multi-channel strips clicking in the box above the DO: box pops-up a Set Direct Out list:Set Direct OutHighlight the required channel. This will be fed to the logical output assigned in the Mixer Route page or by clickingon the DO XLR icon in the Mix page.Selecting StripsStrips can be selected by clicking on the label at the top of the strip which turns orange to show it is selected.Selection uses the conventional modifier logic: Clicking a second strip while holding SHIFT selects all strips inbetween and strips can be individually added or subtracted from a selection by clicking with the Ctrl key helddown. Ctrl + A selects all strips. Strips can be selected by type using the Select context menu.Mixer : Configure Page 10 - 147