V6 User Manual 1.00.book - Studio General

A decent stereo mix would appear as a vertically shaped cloud as shown in the example below:Phase-Oscillo floating WindowPhase-Oscillo configurationThe Phase-Oscillo plug-in has several buttons to configure it’s operation.Oscilloscope buttonThis switches the oscilloscope display on and off. If set to off, only the phase meter is displayed.Sample interpolationWhen this switch is on, the samples of the signals displayed on the oscilloscope are interconnected, resulting in anincreased readability of the display.SetupThis button opens the set-up pane with further optionsWorking PriorityChoose one of these switches to select the amount of CPU time of the host PC which can be consumedby the plug-in, and therefore influences the redraw speed and accuracy of the oscilloscope. The higherthe priority, the more CPU time is assigned to the plug-inDrop frame displayDepending on the chosen working priority of the Phase-Oscillo plug-in might not get enough CPU time to continuouslyredraw the display. The drop counter displays the amount of frames which could not be drawn because oflack of CPU time since the start of the actual Pyramix session.Left and Right channel selectorIf the plug-in is inserted on a bus with more than two channels (e.g. a surround bus or a multiple stereo bus), thesetwo selectors allow you to select the appropriate channels for the left and right input of the plug-in. On a surroundbus, you might for example select the left front and right front channels to be displayed on the Phase-Oscilloplug-in.Effects and Plug-Ins : Phase-Oscillo 13 - 241