V6 User Manual 1.00.book - Studio General

First select the Clip or group of Clips, then select the desired Jog-Wheel EditingMode from the choice of:MoveMove And XFadeTrim InTrim OutTrim Fade InTrim Fade OutTrim Fade In X (Symmetrically)Trim Fade Out X (Symmetrically)Trim Sync PointSlide MediaEditing Modes > Insert Mode >OverwriteInsert TrackEditing Modes > Remove Mode >RemoveRemove and RippleEditing Modes > Snap Mode >Don’t SnapHead to EndTail to BeginningHead to NearestTail to NearestPrevious Clip Trim OutPrevious Clip Trim Fade OutPrevious Clip Trim Fade Out X (symmetrically)Previous Clip Trim Source OutNow simply move the jog wheel to Move, Trim, or Slide Media of the selected Clip(s)Pressing the Spacebar or Enter confirms the change(s), Esc cancels.When checked, any clip placed so that it overlaps an existing clip will overwrite thepart of that clip where the two overlap.When checked, any clip placed on a track will be inserted into the track and will rippleall other material on the track later in time (to the right) by the length of the clipbeing inserted.When checked any selected material will simply be removed from the Timeline.Everything else will be left intact and in the same place.When checked any selected material will be removed from the Timeline. Everythingelse to the right (after) the removed material will be Rippled (moved) to the left (earlier)to take up the space left by the removed material.No snap mode set. This mode doesn't affect the behavior of objects placed on atrack. Behavior follows the existing Insert and Remove modes.This mode will cause the beginning of any clip placed on a track to snap to the endof the last clip on the track, abutting the head of the new clip to the end (tail) of the lastclip.This mode will cause any clip placed on a track to snap to the beginning of the firstclip on the track, abutting the tail of the new clip to the head of the first clip.This mode will cause any clip placed on a track to snap the head of the clip to thenearest edit point or mark on the track. This includes the head or tail of existing clips onthe track, as well as the Play Head Cursor, Mark In, Mark Out, Named Markers, or CDMarks. The clip will interact with existing clips according to the Insert Mode setting.This mode will cause any clip placed on a track to snap the tail of the clip to the nearestedit point or mark on the track. This include the head or tail of existing clips on thetrack, as well as the Play Head Cursor, Mark In, Mark Out, Named Markers, or CD Marks.The clip will interact with existing clips according to the Insert Mode setting.Menus : Edit 26 - 450