V6 User Manual 1.00.book - Studio General

changed, but their output Patches from speakers in the Monitor to physical outputs can. They and each of theirdown-mixes can be enabled/disabled in order to determine which ones are visible in the main Monitor page.The Configure page is divided into four main areas; Speaker Sets and Down-Mixes, Available Sets, OutputSpeakers Patch and Delay[ms], Main Grid and Down-Mixes and Output Metering Patch.Available SetsTo select an existing Speaker Set in order to view or alter its settings, click on its title in the Available Sets list. Thelabel will become underlined and the Set’s parameters will appear in the grid. If the Set has Down-Mixes alreadydefined there will be one or more tabs next to the Main Tab in the Main Grid and Down-Mixes area.Two sets, Stereo and Surround 5.1 are factory defined and cannot be altered. New Sets and Down-Mixes can beCreated, Duplicated and Deleted using the Command buttons.Max VolTo set the maximum volume attainable click on the value box to highlight it and type the desired value then hitEnter or click elsewhere on the window to save the change.Dim ValueTo change the Dim Level, click on the value box to highlight it and type the desired attenuation value then hitEnter or click elsewhere on the window to save the change.Note: Only negative values are accepted. Positive values revert to 0dB. I.e. Type “-15”Ref VolMonitor Configure WindowMonitor : Configure page 11 - 201