V6 User Manual 1.00.book - Studio General

Effects stems it is common practice to update an element on one stem only. However, the final mix Print Master,which is the sum of all the stems must be updated at the same time. Print Masters Track banks allow the user toforget about arming the Print Master tracks and concentrate on the stems.Filter Arming of Print Masters TracksWhen ticked, arming a Print Master track will not arm the other Print Master tracks.No Tallies for Print Masters TracksWhen ticked, record tally commands are filtered out for the Print Masters tracks.Serial PortConfigureOpens the COMM422 Configuration dialog.Please see: Serial Port on page 541Transport Commands Filtering• Filter Transport Commands Except Edit On/Off When ticked all transport commands apart from Edit Onor Edit Off are filtered out.• Process Stop AnywaySome controllers send a Chase Off command for Stop. If you need this command when filtering Transport Commands,checking the box will allow it through.Note: These filter settings are mainly relevant where multiple controllers are in use. E.g.where a Mixing console controls monitoring and recording.Edit On/Off Frame Alignment and DelayEdit On and Edit Off boxes enable delays (in ms) to be entered.Note: 0 = Immediate Punch, 1 = Align to next Frame boundary, 2 or more = Align to thegiven following Frame boundary.Edit Preset (Track Arming) MappingThe Map Track # combo box allows you to select a track between 1 and 96 to be mapped to a choice made in thesecond combo box from:• Default• No change• Always Off• Always Onor any track between 1 and 96This function is useful if more than one Pyramix is to be controlled by the same controller. E.g. with two machinesset up to record 32 tracks each, Pyramix one is mapped 1 - 1 to 32 - 32 and Pyramix two is mapped 1 - 33 to 32 -64Settings : Remote Control 27 - 546