V6 User Manual 1.00.book - Studio General

No Sound on Live InputsPlease carefully check the following points if there is no sound present on live inputs:None of the connected inputs are muted (MUTE ON).None of the connected inputs are in SOLO mode. In this case, all other inputs are muted.The DSP Load (displayed at the bottom the Pyramix window) should be in a range of 20% to 90%. A higher levelcould produce clicks or occasionally mute the audio inputs.In the I/O Status window (right click on the bottom of the Pyramix window):• All Input LEDs (corresponding to physical connections) should be active (light green).• The Lock LED (corresponding to the chosen Sync Source) should be active (light red) and not flashing.In the Mixer Settings window (right click on the mixer and choose Settings):In the General Tab page:• The project's Sampling Rate must match the external studio equipment's settings sampling frequency.In the I/O & Sync Tab page:• The Sync Source must be chosen so there is only one Sync Master for all connected equipment.• The Input Format must match the format of the incoming audio signal.In the specific Tab page of each possible daughter card:ADAT Tab: Only relevant for the outputs.AES/EBU Tab:• If the Reference is not in Auto mode and the Sync Source (in the I/O & Sync Tab page) is in Audio Inputmode, there should be a physical connection to the chosen reference.• If the Sampling Rate Converters are set to Ref 1/2, 3/4, 5/6 or 7/8, the corresponding Inputs are muted.Note: This is valid for the AES/EBU with SRC daughter card only.DUAL Tab:• If the Reference is not in Auto mode and the Sync Source (in the I/O & Sync Tab) is in Audio Input mode,there should be a physical connection to the chosen reference.• If the input level is simply too low, increase the Input Gain.SDIF Tab:• The Format (SDIF2 or SDIF3) must match the format of the incoming audio signal. Make certain the SDIFdaughter card is only connected to DSD.TDIF tab:• If the Reference is not in Auto mode and the Sync Source (in the I/O & Sync Tab) is in Audio Input mode,there should be a physical connection to the chosen reference.MADI (ver1 or ver2) Tab:• Input Groups must be set accordingly to the used inputs.• To activate the inputs 57 to 64, please set the MADI card to Extended Mode.• In Audio Sync Source the outgoing MADI Word Clock should match the external equipment MADI WordClock.• In MADI Word Clock Sync Source, the external incoming Word Clock should match the one set in theMADI card.Troubleshooting : No Sound on Live Inputs 28 - 552