V6 User Manual 1.00.book - Studio General

To add a control to a link group, right-click on the knob or button to display its Link Status and Automation Statuspop-up window. E.g. this is the pop-up for an input gain control.:Group assignment mode buttonsStrip Tools - Link and Automation StatusThese four buttons define the link mode of the control. Four choices are available:NoneGroupExclusiveGroup ExclusiveThe control is not a member of any group.The control is a member of the selected group. When you move (or switch) this controlor any other control which is a member of this group, all the members of thegroup will move (or switch) along with it.This mode is only available for switches. With this mode selected, when this switch ison, all the other members of the group will be switched off.This is a mode which has a superior effect on all groups which are set to GroupExclusive. When any of the groups which are set to Group Exclusive is switched on,all the other groups set to Group Exclusive will be switched off.Grouped controls are indicated by a yellow L in the corner of the control ‘block’.Strip Tools - Grouped ControlsFactor X SliderInvertWorks only on continuous (rotary or linear) controls. It determines the gearing ofthis control in relation to other members of the group and vice versa. E.g, assumethe input gain of strip tools #1 and the input gain of strip tools #2 are both assignedto group one. The scale factor of the gain of strip tools #2 is set to 2. Now when youchange the gain of strip tools #1 by 1 dB, the gain of strip tools #2 will change by 2dB’s.Also works only on continuous controls. It inverts the effect of the movement forthis control caused by another group member or vice versa. E.g, assume the inputgain of strip tools #1 and the input gain of strip tools #2 are both assigned to groupone. The invert button of the gain of strip tools #2 is on. Now when you increase thegain of strip tools #1 by 1 dB, the gain of strip tools #2 will diminished by 1 dB.Strip and Bus Tools : Bus Tools 15 - 287