V6 User Manual 1.00.book - Studio General

Auto-Write Mode - Write & HoldThe automation starts writing a new pass when the control is touched. The value whenthe control is released will continue to be written until the transport stops.Auto-Write Mode - Trim & Release The automation starts updating the current pass when the control is touched and stopsupdating when the control is released.Auto-Write Mode - Trim & Hold The automation starts updating when the control is touched but continues when thecontrol is released and stops only when the transport stops.Release Mode - SnapRelease Mode - Auto-ReleaseRelease Mode - Write to NextRelease Mode - Write to EndMaintain to Next InterpolateRelease Auto-WritingAutomation TracksAutomation SettingsA straight jump is made from the current control value to the value written in the previouspass.An interpolation is created from the current value to the value written in the previouspass. I.e. a fade. The length of this is defined in Automation Settings > Auto-ReleaseTime.The same value is kept after the last written point until the next point is found in the previouspass.Writes the current value to the end, ignoring previously written points. (If any)The current value(s) are maintained until the next interpolated point(s). This is potentiallyuseful when deleting automation points or when inserting a Snapshot to Cursor.Immediately releases all controls currently recording automationOpens the Automation Tracks window. This view allows the automation versions for aspecific control to be displayed. Once the desired control has been located in the treeview, simply double-clicking on the control will update the Automation Track VersionswindowOpens the Settings > All Settings > Application > Automation page which allowsautomation parameters and settings to be definedWorkspacesWorkspaces menuSave >Save Workspace 1 Save Workspace 1Note: Save Workspace 2 to 10 omittedUpdate Current WorkspaceUpdates the current Workspace with current settingsRecall >Recall Workspace 1 Recall Workspace 1Note: Recall Workspace 2 - 10 omittedRecall Previous WorkspaceRecall Next WorkspaceToggles backwards through the list of available WorkspacesToggles forwards through the list of available WorkspacesMenus : Workspaces 26 - 473