V6 User Manual 1.00.book - Studio General

Send In/Out Preset optionsBy default, Pyramix sends Edit Video In/Out and Edit Audio In/Out points when an In/Out point is set in the TransportControl panel. These options enable these commands to filtered out if necessary.• Filter In/Out Preset (video)• Filter Audio In/Out PresetStatus Bit Filtering OptionsSome SonyP2 devices do not report the Standby bit correctly (always in Standby). In this case the Pyramix TransportWindow reports Standby status continuously, thereby hiding the true status. You may wish to set filter if thetarget machine fails to report standby correctly.• Filter the Standby bitEdit Preset channel optionsEdit Preset in the 9-pin P2 protocol world means Track Arming.These options enable Track Arming commands to be filtered out if required.• Send Analog Edit Preset (A1..A2)• Send Digital Edit Preset (D1..D8)This feature is mostly relevant where a console or a third-party record/monitoring controller is used for recordcommands.Edit Preset Record OptionsThese 3 options Inhibit Recording when one of the Video/Timecode/Assemble Edit preset modes is checked andthe corresponding track is armed. In a typical TV workflow, when audio is layed back to the tape, it is essential toprevent the video track entering record (edit) These options avoid nasty accidents.• Inhibit Video Record• Inhibit TimeCode Record• Inhibit Assemble RecordThis feature is mostly relevant where a console or a third-party record/monitoring controller is used for recordcommands.Settings : Remote Control 27 - 542