V6 User Manual 1.00.book - Studio General

Further Mixer Configuration OptionsMixer Context Pop-up menuThe entries on this menu vary according to where you right-click on the mixer surface. At the top of the menu theentries concern the specific mixer component under the mouse cursor when you right click. The next section ofthe menu has entries which affect the Strip. Entries from Mixer to the end of the menu affect the entire mixer andare available wherever the mouse is right-clicked.Mixer > ShowShow AllShow / Hide >Makes all input strips and buses visibleSelects Strips and Buses to be shown or hidden. When checked, the Buses orstrips are visible on the console surface. Both Show and Hide access the same lists.Mixer Show / Hide pop-upMinimizeWhen checked, Mixer window is minimizedAutomation >IsolateThese menu choices toggle the Automation mode for the entirePlay mixer. Please see: Dynamic Automation Modes on page 264RecordAuto-writeMemory >Settings >The choices here enable mixer presets to be saved loaded and managed.Please see: Mixer Presets on page 189General... Opens the Mixer Settings window at the All Settings > Hardware > Hardware >Formats & Sync page. Please see: Formats and Sync on page 484Enable Delay Compensation Enables Delay Compensation for the mixerDitheringRemoveAuto-connectWizard...Show VS3 Plug-Ins InfoOpens the Dithering window. Please see: below and Dither on page 292 for anexplanation of the need for ditherSelect All Strips, All Buses or All to remove groups of mixer components or everycomponent.Automatically connects the Mixer inputs and outputs using the available inputs andoutputs of the installed daughter card (s) and the Mixers Preferred Monitoring OutputsLaunches the Configuration Wizard. Please see: Mixer Configuration Wizard onpage 175Pops up the VS3 Plug-Ins Information window. Please see: VS3 Plug-Ins Informationon page 223Mixer : Configuring a Blank or Existing Mixer 10 - 187